Module category: Tools

• Solutions
  • Parameters
  • Input Ports
  • Output Ports
  • Examples

Solutions

COVISE application module for calculating Plot3D solution data (data read by ReadPlot3D)

Solutions has been tested with Covise Release 1 on SGI.

Parameters

Name	Type	Description
calctype	choice	VELOCITY P_STATIC (static pressure) P_TOTAL (total pressure) M (momentum) CP (pressure coefficient) T_STATIC (static temperature) T_TOTAL (total temperature) MACH (mach number)
gamma	float	ratio of specific heats
cp	float	specific heat at constant pressure (not the pressure coefficient)
base	choice	Chooses which of the following reference bases is used.
Tref	float	reference temperature
cref	float	reference sound speed

Input Ports

Name	Type	Description
requireddensity	Float Float	density
optionalmomentum	Vec3 Vec3	x-, y-, z-momentum
requiredenergy	Float Float	energy per volume unit
optionalrhou	Float Float	rhou = 1st component of momentum
optionalrhov	Float Float	rhov = 2nd component of momentum
optionalrhow	Float Float	rhow = 3rd component of momentum

Output Ports

Name	Type	Description
outputsolution	Float Float Vec3 Vec3	calculated data e.g. velocity (specified by parameter) calculated from density and momentum (input)

Examples

The example net below gives you the possiblity to calculate e. g. the pressure, and to display the distribution of the pressure on the surface using a colormap.

Figure: covise/net/examples/Solutions.net